|
Anagraph vinyl cutters are very
versatile tools, especially if you have
the correct software. You'll be able to
cut prints from Encad and HP DesignJet
printers. For an excellent source of
information, ideas, and experiences
consider participating in newsgroups on
the Internet.
The cutter has a series of values stored
in its memory, which permit it to adjust
the plotter's performance. Default
values have been preset by the
manufacture, which you may need to
adjust. In order to access the service
menu, you need to
press and hold both the menu and enter
keys, the menu will appear.
After making adjustments in this menu,
always run tests on the equipment to
ensure that you are getting the pressure
you want and need. It is also advised
that you test with a gram gauge to see
that you are getting the pressure you
want.
Finally, it is strongly recommend that
you retain the default settings. This is
in case you want or need your Anagraph
vinyl cutters set to the original
performance. It is also recommended that
you not consider altering the settings
unless you are extremely confident in
your expertise. If you aren't, then seek
assistance from a professional.
|
